My Device Forums

Future Development => Requests => Topic started by: connectednet on January 17, 2013, 01:45:13 PM



Title: Macro Driver
Post by: connectednet on January 17, 2013, 01:45:13 PM
Hey Matt,

I was wondering if the SDK support the abbility to make a driver that will enable you to run a macro that sends both an RF command (to the processor) but also send local IR commands (source device) simultaneously.


Title: Re: Macro Driver
Post by: Matt on January 18, 2013, 09:45:27 AM
Hey Matt,

I was wondering if the SDK support the abbility to make a driver that will enable you to run a macro that sends both an RF command (to the processor) but also send local IR commands (source device) simultaneously.

I don't believe you need the SDK or even a driver to achieve this.

Simply make the button standalone (right click, properties -> output) and then create a macro.  Inside the macro you can output a local IR code directly from the remote and also trigger a system macro on an XP processor.


Title: Re: Macro Driver
Post by: connectednet on January 18, 2013, 06:06:50 PM
The problem is it isn't an XP processor. Never mind.


Title: Re: Macro Driver
Post by: Matt on January 18, 2013, 07:24:01 PM
The problem is it isn't an XP processor. Never mind.

All drivers run directly on the XP processor, so in your case, no it's not possible.


Title: Re: Macro Driver
Post by: connectednet on January 18, 2013, 11:08:33 PM
Nevermind, I was reffering to a T1 and ZRP.


Title: Re: Macro Driver
Post by: Matt on January 19, 2013, 10:22:51 AM
Nevermind, I was reffering to a T1 and ZRP.

There isn't an SDK for the ZRP.  RTI never released it.