|
Title: Macro Driver Post by: connectednet on January 17, 2013, 01:45:13 PM Hey Matt,
I was wondering if the SDK support the abbility to make a driver that will enable you to run a macro that sends both an RF command (to the processor) but also send local IR commands (source device) simultaneously. Title: Re: Macro Driver Post by: Matt on January 18, 2013, 09:45:27 AM Hey Matt, I was wondering if the SDK support the abbility to make a driver that will enable you to run a macro that sends both an RF command (to the processor) but also send local IR commands (source device) simultaneously. I don't believe you need the SDK or even a driver to achieve this. Simply make the button standalone (right click, properties -> output) and then create a macro. Inside the macro you can output a local IR code directly from the remote and also trigger a system macro on an XP processor. Title: Re: Macro Driver Post by: connectednet on January 18, 2013, 06:06:50 PM The problem is it isn't an XP processor. Never mind.
Title: Re: Macro Driver Post by: Matt on January 18, 2013, 07:24:01 PM The problem is it isn't an XP processor. Never mind. All drivers run directly on the XP processor, so in your case, no it's not possible. Title: Re: Macro Driver Post by: connectednet on January 18, 2013, 11:08:33 PM Nevermind, I was reffering to a T1 and ZRP.
Title: Re: Macro Driver Post by: Matt on January 19, 2013, 10:22:51 AM Nevermind, I was reffering to a T1 and ZRP. There isn't an SDK for the ZRP. RTI never released it. |